sales@battemachinery.com

+86-371-67991755

Current position: Batte Machinery Zhengzhou Co.,Ltd > News > Views
Introduction of pipeline pump
   The internal rotation of the water rose too, the internal pressure becomes small, due to the atmospheric pressure, the water enters the turbine part. In fact, the pump is generally installed directly on the pipe road, called the pipe pump.

   Small pipe pumps are often used in the water pressure shortage of the water pipe to increase the water pressure, but also for other water cycle system.There are hot water pipe pump, micro pipe pump, etc........

   General single-phase 380v/3 plastics PPO 12 11 3 2 4 12 10 9 8 6 5 3 2 pipeline pump, the motor casing, a motor stator, a motor rotor, a sealing sleeve 4, a water pump shell, a water pump impeller and end cover 7, a motor shaft, a filter, an end cover slot, a sealing ring 11 and graphite bearing component, which is characterized in that a sealing sleeve of the motor stator and electric machine rotor shielding is separated, and the sealing rubber ring seal, in the end cover 7 in a filter, the end cover 7 on the end cover slot 10, bearing the graphite sliding bearings, water pump impeller using modified polyphenylene ether, motor shell 1 uses a die cast aluminum alloy or cast iron material, the power supply voltage common phase 220v/ AC. power + watt to several hundred watts range.

©2015 Batte Machinery Zhengzhou Co,.Ltd. All rights reserved.  sales@battemachinery.com
Batte Machinery Zhengzhou Co.,Ltd ,as extrusion pump manufacturers,virtue of its power to make high quality extrusion pump,extrusion gear pumps,extrusion melt pumps,etc.